JeffDav wrote:fg6e wrote:Which him commands are you after i have both the MK1 & MK2 him modules. i have a ELM 327 but don't know how to log can bus signals.
FGX do run a FG MK2 him module
I do know that FGX do run different steering wheel switches over FG,FG MK2 they run different ohms.
I would assume the "wake up command might be in the cluster" I know SZ Territory do run the same BEM between SZ 1 (FG MK2) & SZ 2 (FGX Falcon). But the FGX Falcon do run a separate BEM over FG,FG 2. Good work getting the sync system to work in a MK1. Back to the workshop manual and do some more reading up. Guess ill be looking for a cheap FGX ICC
Do yourself a favor and get a whole dashboard or at least a dash harness too.
I changed over the dash harness (**** of a job) but the icc is a slightly different size so some grinding was required to make it fit. whilst I'm sure you could make up an adapter there are a lot of cables and with the modification required it would be easier to just swap the dash over, only took me about an hour to get the dash out, and about 3 hours modifying cables before refitting.
Did you use the FGX Loom in the FG or FG loom modified with the sync modules ? What cables did you have to modify ?