by gruntly69 » Fri Jul 13, 2012 4:32 pm
Yeah here's better images, the left has no cover, the middle a blue(Ford) cover & right has green(GM) cover!
I’ve been testing these VT clusters in different models & it seems the VT series 1 (92078903 level 2o 129??) will only work in that model as when I tried it in a series 2 it did the same things as when I tried it in a VX (both temp & fuel when straight to top, the tacho & speedo worked but definitely weren’t right, the odo didn’t even tick over 1Km but the trip meter looked reasonably close so go figure!).
Yet the triple LCD cluster (level 3oP 12883) I have worked in a VT series 2 but the tacho didn’t like working when at idle & was a little sporadic even when it was working so it could even been a fault in that cluster & it seemed the temp gauge started at ¼ almost but when at operating temp was just on ½ which is fairly normal.
So going with that testing possibly the triple LCD I have may work in a VX even though they have the completely different eeprom setup, but I’ll test this next time I can!
But the air bag section of the eeprom’s no matter which cluster needs to be set for correct configuration otherwise it will need to fault code reset in the air bag module (not cluster) if it trips it out after putting right config in the eeprom!
The 2 cars I tested them in had 92096563 (single LCD) in the VX & 92087560 (single LCD) in the VT s2!
You do not have the required permissions to view the files attached to this post.