Accessing the hidden HSV EDI Menu for the Holden VE II Commodore
- Document Contents
- Introduction
- Entering the HSV EDI Service Mode
- Document Information
- Information on Accessing and Configuring the Hidden HSV EDI Service Menu
- Vehicle: Holden Commodore (VE II)
- Copyright Owner: Matthew Jones (Matti Jones) (ZerOne)
- Document Visits: 5836
- Created: Thu Dec 20, 2012 12:47 am
- Revised: Thu Dec 20, 2012 12:52 am (Rev 3)
-
-
This Document describes the HSV Enhanced Driver Interface Service Menu Mode, how to enter this mode, and what the various settings in this mode change.
-
-
Displaying the EDI Service Page
1. The battery should be fully charged (or a booster battery connected)
2. Turn key to Accessory On
3. Ensure Infotainment System is switch on
4. Press EDI button on Steering Wheel to display EDI view
(EDI/about page will be displayed for temporarily if ignition has previously been off for more than 2 minutes)
5. Select the EDI Main Menu page by touching the HSV button in the bottom left corner of the screen if the Main Menu is not already being displayed.
6. Touch the HSV button in the bottom left corner of the Main Menu to display the EDI/about page.
7. Touch the bottom right corner of the EDI/about page for 5 seconds to display EDI/service page.
Note: There is no visual button on the screen to touch, just touch the bottom right corner for 5 seconds.
8. The EDI Service page contains the following menu items:
Update Firmware
This is used to update the software in the EDI using the Glovebox USB Connector.
Update Factory
This is used to update the Factory configuration settings in the EDI
Information
General Diagnostics
SBZA Diagnostics (vehicles fitted with Side Blind Zone Alert only)