Welcome Anonymous !

Everything you need to modify your ride
 

Home

Diagnostic Trouble Code Results for 029 for the Daewoo Tosca (V250)

Tosca (V250) Daewoo

Diagnostic Trouble Code: 029

Diagnostic Trouble Code Name: Left Front Window Motor Circuit

Vehicle Make: Daewoo

Vehicle Model: Tosca (V250)

Diagnostic Code Entered By: ZerOne

Diagnostic Code Entered On: Wed Oct 06, 2010 11:00 pm

Please Note: The DTC Information provided has been randomly generated.

To view the correct Diagnostic Code Information, Please Login, or Register.

 

Diagnostic Trouble Code Description: 

Cooling Fan Relay 2 and 3 Control Circuit

Possible Sensor Faults
ECM

Possible Related Diagnostic Trouble Codes
DTCP0481

Circuit / System Description
The following DTCs are for the cooling fan relay control circuits controlled by the engine control module (ECM):

  • DTC?P0480--low speed cooling fan relay control circuit
  • DTC?P0481--high speed cooling fan relay control circuit
    Ignition?1 voltage is supplied to the cooling fan?1 relay from the IGN?E fuse. The ECM controls the low speed cooling fan relay by grounding the low speed cooling fan relay control circuit.

    Ignition?1 voltage is supplied to the cooling fan?2 relay from the IGN?E fuse. The ECM controls the low speed cooling fan relay by grounding the low speed cooling fan relay control circuit.

    The ECM grounds the cooling fan relay control circuits through an internal solid state device called a driver. The primary function of the driver is to supply the ground for the component being controlled. Each driver has a fault line that is monitored by the ECM. When the ECM is commanding a component ON, the voltage potential of the control circuit should be low, near 0?volts. When the ECM is commanding the control circuit to a component OFF, the voltage potential of the circuit should be high, near battery voltage. If the fault detection circuit senses a voltage other than what is expected, the DTC will set.

    The ECM will monitor the control circuit for the following:
  • A short to ground
  • A short to voltage
  • An open circuit
  • An open relay coil
  • An internally shorted or excessively low resistance relay coil
    When the ECM detects any of the above conditions, the DTC will set and the effected driver will be disabled.

  • cron
    • View new posts
    • View unanswered posts
    • Who is online
    • Statistics
    • In total there are 162 users online :: 0 registered, 0 hidden and 162 guests (based on users active over the past 5 minutes)
    • Most users ever online was 405 on Sat Mar 30, 2024 1:42 am
    • Registered users: No registered users
    • Total posts 6776
    • Total topics 671
    • Total members 62803
    • Our newest member Dazzak