Ve E1/E2 gauge modules help please

[Voodoojezza]

Hi everyone ive got a ssv my9.5 im wanting to put the binncle gauges in problem is i have two sets one e1 and one e2 the e2 looks better and is in better condition but has no module can i use the e1 module even though the read outs on gauges are different or will i need to calibrate the gauge i see you can buy new faces off ebay but the look of the e2 face appeals to me more
hope this all makes sense
cheers
Jezza'

06292273_59176251_o.jpg

[TazzI]

Mix and Matching gauges with different series master modules = Incorrect readings.

If you want to use the E2 gauges, you will need to get E2 module. They are unfortunately not cheap so it will cost a bit to get the E2 gauges up and running.

Your best (And much cheaper!) option is to use the E1 gauges.

[OPCDK]

Hi,
Know that this is an old post....but does any of you have a eeprom dump of the High Range ( E2 ) control unit ( VDO Blackbox??
I have an 1. gen Blackbox ( low range ) and have copied the eeprom data from it - my task would be to try reprogram it and put a set of High range gauges on to see if this would work....but need a copy of the eeprom data from the newer Blackbox.
Eeprom is a ST95320 and is located right beside the yellow connector.

Regards Kasper