by ZerOne » Fri Mar 29, 2013 1:39 pm
I think the bars should just bolt up (Not sure about brackets and things like that though).
As for wiring, It wont be a plug and play type thing, however I think things like the spot lamps, and the existing 4 park assist sensors should just plug up ? (Need to check eSI to make sure this is the case).
The DRL LEDs could be simply wired up to the ignition line. (Not sure where the best possible place to pull this from would be at the front of the car).
The extra 2 sensors are used for the blind side assist warning (I think).
Which if you wanted to fit, would require the extra module, and warning LEDs (and trims) near the A pillers.
(I personally would leave them disconnected, until you can either obtain the blind side alert bits cheaply, or work out what to do with them).
Because the park assist only has connectors for 4 front and 4 rear sensors, you would need to disconnect 2 of those to use the side facing sensors, which would mean unpredictable results with the park assist...
I hope this helps (a little bit at least)