The following forum thread is for discussing the Accessing the Power Window Diagnostics for VE and VEII Commodores document, located in our Documents section.
Please try to keep posts relevant, and on topic.
Also, please refrain from using the P.M. system to message the author or posters of this thread.
The chances are if you have a question regarding this document, then others will have the same question too.
Using the Forum allows anyone and everyone to both ask and answer questions.
GM Technical Document Discussion
Power WIndow Dignostics for VE Commodores
Forum rules
To gain access to the Invite Only forum you must be invited by a member of that forum. That member will PM the mods or admins (NOT you) saying that they nominate you for access. THEY will be responsible for your actions. If you don't post and just leech info, you will BOTH be removed. Dont send a PM to the moderators or admins asking for access, you really dont want to see the result. If you submit information, you may simply be invited
To gain access to the Invite Only forum you must be invited by a member of that forum. That member will PM the mods or admins (NOT you) saying that they nominate you for access. THEY will be responsible for your actions. If you don't post and just leech info, you will BOTH be removed. Dont send a PM to the moderators or admins asking for access, you really dont want to see the result. If you submit information, you may simply be invited
9 posts
• Page 1 of 1
by robpagnoni » Sat Mar 09, 2013 4:53 pm
For those that know......How do I remove the power window switch gear from the centre console trim? (without cracking the trim) The trim has already been removed from the vehicle.
cheers...
cheers...
- robpagnoni
- Newbie Modder
- Posts: 2
- Joined: Sat Mar 09, 2013 9:56 am
- Has thanked: 0 time
- Been thanked: 0 time
by ZerOne » Sat Mar 09, 2013 5:03 pm
The power window switch just clips in to the gear shift surround.
Carefully dis-engage the clips around the power window switch (using a small flat headed screwdriver), and push the switch assembly outwards from the trim surround.
(The actual hard part is removing the transmission trim, so if you have gotten that far, then the rest is much easier).
Hope this helps.
Carefully dis-engage the clips around the power window switch (using a small flat headed screwdriver), and push the switch assembly outwards from the trim surround.
(The actual hard part is removing the transmission trim, so if you have gotten that far, then the rest is much easier).
Hope this helps.
by robpagnoni » Sat Mar 09, 2013 5:10 pm
Perfect....thanks!
- robpagnoni
- Newbie Modder
- Posts: 2
- Joined: Sat Mar 09, 2013 9:56 am
- Has thanked: 0 time
- Been thanked: 0 time
9 posts
• Page 1 of 1