Factory Head Unit / Stereo Wiring Information for the Daewoo VE Veritas
- Document Information
- Wiring Information for the factory fitted stereo system
- Vehicle: Daewoo Veritas (VE)
- Copyright Owner: Matthew Jones (Matti Jones) (ZerOne)
- Document Visits: 3423
- Created: Fri Jun 22, 2012 10:44 pm
- Revised: Mon Dec 10, 2012 11:11 pm (Rev 7)
-
-
The following guide outlines the connectors, wire colours, and wiring information for the factory fitted VE Series I Radios.
This includes Level 1 (Omega Models), Level 2 (SV6, SS Models), Level 3 (SS-V, Calais and HSV SWB Models), and Level 4 (Long wheelbase Statesman and Caprice Models).
This guide also includes an important note regarding fitting Late (Model Year 9.5) Head Units to earlier (Model Years 2006 to 2009) Vehicles.
-
-
To remove the factory HVAC / Radio head Unit from the vehicle, you will require the following tools.
1 x Phllips head screw driver,
1 x Small Flat Headed screw driver, for unclipping the radio antenna connector(s)
-
-
Firstly, a big thankyou goes to DoubleDip for posting this important information in the forums !!!!!
Without this information, many members were blowing fuses when fitting late model head units to earlier model vehicles.
Procedure for installing Version 9 (MY09.5) radio into earlier built vehicle (pre MY09.5)
During the life of VE and WM vehicles there have been several revisions to the radio.
These different radios have different version numbers assigned to them.
Vehicles built prior to 27/10/08 (Introduction date of MY09.5 - BSI) will have a version 4, version 5 or version 6 radio.
At MY09.5 introduction, the version was updated to version 9.
In some cases when replacing a radio, dealers will be supplied a later version radio by Bosch.
Installing a version 9 radio into an earlier built vehicle will result in fuse 4 (radio) blowing.
In order to prevent this happening, a modification to the wiring harness is required.
Follow the procedure below when installing a version 9 radio into an earlier vehicle.
Version 9 radios can be identified by the Holden P/N or Bosch P/N on the unit. Refer to following table which lists all version 9 P/N?s.
Holden P/N Bosch P/N
92228621 7648791920-002
92228618 7648794920-002
92228617 7648795920-002
92228615 7648796920-002
Procedure:
1. Disconnect the battery
2. Remove the radio.
3. Locate pin 4 of connector X4 at radio.
4. Cut the wire going to pin 4 and insulate both ends with heat shrink or similar.
5. Refit the radio and reconnect the battery.
6. Test operation of the radio.
-
Connector X1
Pin Wire Colour Details 1 Light Blue Speaker RR Door (-) 2 Dark Green Speaker RF Door (-) 3 Grey Speaker LF Door (-) 4 Yellow / Red Speaker LR Door (-) 5 Dark Blue Speaker RR Door (+) 6 Light Green Speaker RF Door (+) 7 Brown Speaker LF Door (+) 8 Brown Speaker LR Door (+)
Connector X2
Pin Wire Colour Details 9 Light Blue Front Center Speaker Output (+) 10 Orange / Blue Battery Positive Voltage (RHD) 10 Red / White Battery Positive Voltage (LHD) 11 Not Used 12 Black Ground 13 Orange Front Center Speaker Output (+) 14 Orange / Blue Battery Positive Voltage (RHD) 14 Red / White Battery Positive Voltage (LHD) 15 Not Used 16 Black Ground
Connector X3
Pin Wire Colour Details 1 Not Used 2 Dark Blue / White Common Auxiliary Audio Signal (-) 3 Red DVD Auxiliary Audio Left Signal (+) 4 Orange / Black Navigation Mono Audio Signal (-) 5 Pink Left Audio Signal Output DVD(+) 6 Green / White Common Audio Signal (-) 7 Not Used 8 Not Used 9 Dark Green DVD Auxiliary Audio Right Signal (+) 10 Pink / Black Navigation Mono Audio Signal (+) 11 Dark Blue Right Audio Signal Output DVD (+) 12 Not Used
Connector X4
Pin Wire Colour Details 1 Light Blue Telephone Audio Signal (-) 2 Not Used 3 Not Used 4 Orange / Blue Battery Positive Voltage (RHD) 4 Red / White Battery Positive Voltage (LHD) 5 White Telephone Audio Mute Signal 6 Green Low Speed GMLAN Serial Data 7 Orange / Black Telephone Audio Signal (+) 8 Not Used 9 Not Used 10 Orange Amplifier Mute Control 11 White Amplifier Enable Signal 12 Not Used
Connector X7
Pin Wire Colour Details 1 White Video Connector (VGA) - Blue 2 Not Used 3 Red Video Connector (VGA) - Red 4 Not Used 5 White / Black DVD Video Input Ground 6 Not Used 7 Not Used 8 Not Used 9 Not Used 10 Black Ground 11 Dark Green Video Connector (VGA) - Green 12 Not Used 13 Yellow Video Connector (VGA) - Sync 14 Red DVD Input Video Signal 15 Not Used 16 Not Used 17 Not Used 18 Not Used